APSEMI
先進光半導體

中文

中文

English

繁體

Pусский

產品編號檢索/替代型號參數查詢

先進光半導體

------熱電堆溫度傳感器
TO46 封裝
TO39 封裝
------碳化硅及晶圓
碳化硅光耦繼電器
碳化硅MOS
碳化硅SBD
碳化硅晶圓
------通用型光耦繼電器
1路常開及2路常開1a2a
0~80V
0~180mA
200~900mA
1000~2000mA
2100~5000mA
100~250V
0~180mA
200~900mA
1000~2000mA
2100~5000mA
300~400V
0~90mA
100~180mA
200~500mA
600~800V
0~90mA
100~180mA
200~600mA
1000~1500V
20~100mA
1路常閉及2路常閉1b2b
0~80V
0~180mA
200~900mA
1000~2000mA
2100~5000mA
100~250V
0~180mA
200~900mA
1000~2000mA
2100~5000mA
300~400V
0~90mA
100~180mA
200~600mA
600~800V
0~90mA
100~180mA
200~600mA
常開常閉雙路觸點1a1b
0~60V
100~500mA
1000~2000mA
200~250V
100~250mA
350~400V
50~90mA
100~200mA
600V
------柵級驅動光耦
APPL-P314
APPL-W314
APPL-P341
APPL-W341
APPL-P343
APPL-W343
APPL-P480
APPL-W480
APPL-4800
------高速通信光耦
APPL-2501/APPL-2531
APPL-2601/APPL-2631
APPL-0601/APPL-0631
APPL-M61L/APPL-M75L
APPL-4502/03/04
------固態繼電器光耦
APH0213/0223
APH1213/1223
APH2213/2223
APH3213/3223
APH4213/4223
------常用型光耦
光伏光耦
ALP-190/ALP-191
APPL-3902/APPL-3904/APPL-3905/APPL-3906
APV1121/APV2221
可控硅光耦
MOC3020/21/22/23
MOC3041/42/43
MOC3051/52/53
MOC3061/62/63
MOC3081/82/83
晶體管光耦
AFH615A-4
AFH6156-4
AFH628A-3
AFH6286-3
4N25/4N35
MOSFET驅動光耦
APV1122
APV1123
APV1124
APV1125
光纖耦合器
光耦系列晶圓

產品詳情

APY414EH替換AQY414EH SSR PHOTO RELAY SPST-NC (1B) 0V ~ 400V 120mA(1)

收藏：0

86-755-83666556 咨詢我們

產品詳情

關聯產品（代替）

產品應用

文檔下載

APS PN	APY414EH	Series	Photo MOS Solid State Relays
Termination Style	PC Pin	Description	SSR RELAY SPST-NC 120MA 0-400V
Circuit	SPST-NC	Number of Circuit	(1 Form B)
Output Type	AC, DC	Voltage-Input	1.14VDC
Voltage-Load	0V ~ 400V	VOFF (Max)(V)	400V
Load Current	120mA	On-State Resistance (Max)	35 Ohms
Mounting Type	Through Hole	Packaging	Tube
Package	4-DIP	Package/Case	0.300, 7.62mm width
Package/Size	4.78x6.4x3.2mm	Topr (Min~Max) (degC)	‘-40~85 ℃

Manufacturer Part Number	Manufacturer	Package	Circuit	Output Type	Voltage - Input	Voltage - Load	Load Current	On-State Resistance (Max)	Package / Case2
AQY414EHAX	Panasonic	4-SMD	SPST-NC (1 Form B)	AC, DC	1.14VDC	0V ~ 400V	120mA	35 Ohms	4-SMD (0.300, 7.62mm)
AQY414EH	Panasonic	4-DIP	SPST-NC (1 Form B)	AC, DC	1.14VDC	0V ~ 400V	120mA	35 Ohms	4-DIP (0.300, 7.62mm)
AQY414EHA	Panasonic	4-SMD	SPST-NC (1 Form B)	AC, DC	1.14VDC	0V ~ 400V	120mA	35 Ohms	4-SMD (0.300, 7.62mm)

光耦繼電器應用

1．Power?storage?system? 蓄電系統

2．Smart?meters?? 智能電表

3．Automatic?meter?reading? 自動抄表?

4．Telecommunications? ? TELECOM電信設備

5．Instrumentation? 測量儀器

6．Medical?equipment? 醫療設備

7．Communications?equipment? 通信設備

8．Programmable?controller? PC設備

9．Security?Equipment? 防范?防災機器

10．OA?equipment? OA設備

11．If?you?are?a?user?experiencing?difficulty?with?solid-state?relays?and?triacs:? 計時器

12．?Microprocessor System I/O Board 在計算機系統I/O板中的應用

1.For Charge and Discharge 充放電用途

AP- Series SSR (APS Photo Relays) is used to switch charge and discharge. We recommend solid state relays for applications where there will be frequent ON/OFF switching.

AP-x Series SSD（APS Photo Relays）用于充電?放電時的切換。
對于ON/OFF切換次數較多的用途，建議使用光電耦合器。

Regular operation
Turn ON both solid state relays for charge and discharge control. Current flows in both directions.

一般情況下
充電?放電控制的光電耦合器均置ON。
雙向均有電流流過

Over-charge prevention
In order to prevent over charging, the solid state relay on the charge control side turns OFF. On the discharge side, current will flow because there is a diode.

防止過充電
為防止過充電，充電控制側的光電耦合器變?yōu)镺FF。
由于放電側有二極管，因此會有電流流過。

Over-discharge prevention
In order to prevent over discharging, the solid state relay on the discharge control side turns OFF. On the charge side, current will flow because there is a diode.

防止過放電
為防止過放電，放電控制側的光電耦合器變?yōu)镺FF。
由于充電側有二極管，因此會有電流流過。

Charge and discharge control is possible by effectively utilizing the internal diodes of the solid state relay.
有效利用光電耦合器內部的二極管，從而可對充電?放電進行控制。

2. For preventing an inrush current into capacitors when charging (pre-charge circuit)防止充電時發生的電容沖擊（預充電電路）

APx Series SSR (APSPhotoRelays), 10A and 20A types of relays are used for preventing an inrush current into capacitors when charging. We recommend solid state relays for miniaturization and 10A and 20A types of relays for high voltages.

AP-x Series SSD（APS Photo Relays）、10A、20A型繼電器用來防止充電時電容產生的沖擊電流。
要求小型的情況下，建議使用光電耦合器、高電壓時為10A、20A型繼電器。

During device startup, the inrush current prevention relay turns ON and the main relay turns ON after the capacitor is charged.
Effective for protection against inrush currents that occur when charging the capacitor.

啟動機器時，用來防止沖擊的繼電器將會置ON，電容充電后，主繼電器將會置ON。
對于電容充電時產生的沖擊電流，可有效地發揮保護作用。

3.For Insulation Detection絕緣檢測用途

APS Photo Relays are used for monitoring storage battery units for insulation deterioration. If the insulation in a unit deteriorates, a ground-fault current passes when the relay is turned ON, and a sensor detects the current. High load voltage type APS Photo Relays are ideal for use with storage batteries, which carry high voltage.

使用APS Photo Relays對蓄電池單元的絕緣劣化進行監控。單元內部發生絕緣劣化的情況下，置ON時將會有接地電流流過，傳感器將會進行檢測。由于蓄電池屬于高電壓，因此適合使用高耐壓型APS Photo Relays。

Inside of a storage battery unit

When insulation of high voltage area and chassis is deteriorated

高電壓部與底盤的絕緣發生劣化時

1. APS Photo Relays is turned on.

APS Photo Relays為ON
2. The current sensor detects a ground-fault current.

電流傳感器檢測接地電流
3. An alarm signal is output.

警報信號的輸出

4.For Battery Monitoring電池監控用途

APS Photo Relays are used in a circuit for monitoring charging voltages of a battery cell group. Compact APS Photo Relays capable of frequent switching are ideal for this type of use. Use of the relays allows for insulation from high voltage areas.

將APS Photo Relays用作電池組（群）充電電壓的監控電路。適合使用小型尺寸、可高頻度開閉的APS Photo Relays。通過使用繼電器，從而可與高電壓部分實施絕緣。

When charging the capacitor

電容充電時

1，APS Photo Relays on the battery cell side are turned ON.

電池組的APS Photo Relays為ON

2，The capacitor is charged.

電容開始充電

When measure

測量時

1.APS Photo Relays on the battery cell side are turned OFF.

電池組的APS Photo Relays為OFF?

2. APS Photo Relays on the measurement side are turned ON.

測量的APS Photo Relays為ON?

3. The voltage of capacitor? (= voltage of battery cell group) is measured.

測量電容電壓
?。ǎ诫姵亟M(群)的電壓）

PHOTORELAYS & CONTACTORS

AQ SERIES PHOTORELAYS

New AQ Series PhotoRelays provides a compact DIP SMD and SOP package along. features greatly improved specifications for use in place of mercury and Mechanical Relays. With 1 Form A Type contact arrangement and high capacity ratings, the NEW AQ Series Relays can be used in applications such as security equipment, fire-preventing systems, industrial machines and HVAC applications such as thermostats, etc. These new Relays available in both surface mount and through hole varieties and are available in both tube and tape and reel packaging styles.

分享網站

APSEMI先進光半導體

APY414EH替換AQY414EH SSR PHOTO RELAY SPST-NC (1B) 0V ~ 400V 120mA(1)

1.For Charge and Discharge 充放電用途

2. For preventing an inrush current into capacitors when charging (pre-charge circuit)防止充電時發生的電容沖擊（預充電電路）

3.For Insulation Detection絕緣檢測用途

APSEMI
先進光半導體